Q. I am looking for a particular USB cable for an older HP printer. The trouble is that I don't know how to describe it. The output and input jacks have varying sizes and dimensions. Is there terminology that describes the various sizes and dimensions, so that I can buy the correct cable?
The dimensions are different on the printer output jack, so it is not the standard USB cable.
The dimensions are different on the printer output jack, so it is not the standard USB cable.
A. I'm in agreement with Benjamin M. It'll be a standard USB A-B cable.
How can I add tackiness to a rubber roller in a printer/copier?
Q. The paper-feed in my old laser printer is having trouble grabbing a sheet.because the rubber wheel has dried out and gotten too slick. Any replacement part would be expensive and has probably already dried up on the shelf. How can I restore some tackiness to the rubber without gumming up everything? Double-sided cellophane tape is a bit too strong. I am counting on the Hobbies and Crafts community for a creative idea.
A. I've just washed the ones that I've had trouble with... soap and water if you can take the roller out.
Otherwise, what I find that's really good to clean various things is white-board cleaner fluid. but start small and see how your roller might react to it.
Your wheel is probably not dried out, but just covered with paper fibers (powder) that no longer permit it to grab well..
Otherwise, what I find that's really good to clean various things is white-board cleaner fluid. but start small and see how your roller might react to it.
Your wheel is probably not dried out, but just covered with paper fibers (powder) that no longer permit it to grab well..
Why does my printer leave half my head off when I print?
Q. At first my printer was having trouble , and I went to the office depoit but now i'm trying to print out invitations and when I print it leaves half my head off . Does anyone know why my printer is doing this , And how can I fix this problem ?
A. You have a giant head.
how to align printer after i missed the offer?
Q. hello, i have just installed new ink cartrige to my hp deskjet printer. from previous troubles i had the printer paused and i forgot about this. after inserting the cartrige i was offered to align the printer but i messed with it. it printed the test page and also the aligning sheet but i cannot set the correct parametres anymore. how can i try it again? it does not print badly, but just to do it correctly.
many thanx.
many thanx.
A. Disconnect the Universal Serial Bus (USB) cable from the back of the product, but leave the product turned on
Open the cover of the product and remove the print cartridges
Close the cover and wait for the Insert Ink Cartridges message to display
Disconnect the power cord from the back of the product and wait for one minute
Reconnect the power cord. If the product does not automatically turn on, press the Power button
Open the cover and reinsert the print cartridges
Close the cover. If prompted, print a calibration page.
Reconnect the USB cable, and try to print a print job from the computer
Open the cover of the product and remove the print cartridges
Close the cover and wait for the Insert Ink Cartridges message to display
Disconnect the power cord from the back of the product and wait for one minute
Reconnect the power cord. If the product does not automatically turn on, press the Power button
Open the cover and reinsert the print cartridges
Close the cover. If prompted, print a calibration page.
Reconnect the USB cable, and try to print a print job from the computer
Powered By Y! Answer
No comments:
Post a Comment